Thermon HSX Manuale Utente

WarmTraceTM HSX™Hot Water Temperature MaintenanceINSTALLATION PROCEDURES

1. Refer to Thermon Installation Procedures, FORM CPD 1014, for general installation procedures, requirements and guidelines.2. Upon receiving heati

Customer: Contractor: Address: Address: Phone No: Phone No. Project Reference:Record 1: Prior to Installation Cable Type: Heater Length: He

Form CPD1014-1008 THERMON . . . The Heat Tracing Specialists®100 Thermon Dr. • PO Box 609 • San Marcos, TX 78667-0609Phone: 512-396-5801 •

2WarmTraceTM HSXFamiliarize yourself with the entire guide prior to installing any heating cable or components. Throughout this guide, the following

3INSTALLATION PROCEDURESCable Type (Catalog No.) Outer Jacket Color Voltage (Vac)HSX 2105-2 Blue 208HSX 2120-2 Green 208HSX 2140-2 Red 208Typical Heat

4WarmTraceTM HSXPrior to Installing Cable. . .1. Verify Electrical Resistance with a megger. • Refer to Cable Testing Section in this Installation G

5INSTALLATION PROCEDURESAttachment Tape (Value Represents Approximate Linear Pipe Length Allowance Per Roll)Where space is a problem, Thermon approved

6WarmTraceTM HSXMaximum Circuit Length vs. Circuit Breaker SizeMaximum Circuit Lengths. . .To prevent excessive electrical currents at the branch circ

7INSTALLATION PROCEDURESFinal Inspection and Documentation . . .1. It is recommended that the circuit be temporarily energized so that the volts, amp

TroubleshootingThe following information is intended to assist in maintain-ing and troubleshooting a heat traced hot water system. The primary goal of

9INSTALLATION PROCEDURESMaintenance Check List. . .As part of an annual maintenance program or after any work (repair or alteration) has been performe